Date:         Thu, 12 Jul 2007 21:29:06 -0400
Reply-To:     Geza Polony <gezapolony@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Geza Polony <gezapolony@SBCGLOBAL.NET>
Subject:      Re: Temp 2 Sensor Questions

Don't feel bad--I have three of them sitting on the shelf, all good.
Replaced them in exactly the same way you did. See Dennis' post, as usual.
The only thing I would add is that there may be something else you bumped
around in there while doing the T2 that made it temporarily run better, like
the little green coax wire to the O2 sensor.

I've found that cleaning the connection with an acidic cleaner works pretty
well, then coating it with clear high-heat spray varnish to prevent it from
corroding again. Or at least soon.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.