Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2007, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 21 Jul 2007 10:41:02 -0400
Reply-To:     Mark Brush <mbrush@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Brush <mbrush@GMAIL.COM>
Subject:      propane rebuild and safety
Content-Type: text/plain; charset=ISO-8859-1

I just fitted my old propane tank with new valves and new regulator. I'm ready to hang it back on the van, but I'm a little concerned about safety. The fill valve is manual in place of the old auto stop valve. Is this a safe way to go? Can this newly valved tank handle expansion of the propane? Did the old fill valve and or regulator have some kind of relief valve for increased pressure? I read an archived post that seemed to suggest that this config. could not handle expansion and posed a safety risk.

Thanks again for you insights!

Mark


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.