That is a better site than I had found! I guess I will stop using my stainless electrodes...What I found with my three rebar rods was that they became less conductive over time. I would have to beat and scrape them to get fresh iron exposed and then all worked well again for a few days. That's why I used stainless after a while, but I see now that was not such a good idea...science is good but you have to use it cautiously sometimes eh! Pascal
-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of mordo Sent: July 17, 2007 2:57 PM To: vanagon@GERRY.VANAGON.COM Subject: electrolytic rust removal technique - very simple Here's a good tutorial: |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.