Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2007, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 21 Jul 2007 11:41:44 -0700
Reply-To:     John Goubeaux <john@UCSB.EDU>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         John Goubeaux <john@UCSB.EDU>
Organization: UCSB
Subject:      Re: 90 cooling problem
In-Reply-To:  <vanagon%2007072113252000@GERRY.VANAGON.COM>
Content-type: text/plain; charset=ISO-8859-1; format=flowed

Thanks guys,

I have to say, when I am not fixated on the prospect of major engine work, I actually am enjoying the trbl shooting aspect of all this (:

So after dbl checking all connections, cleaning the coolant deposits at the sensor and pulling and checking the plugs I did the following:

Ran the engine at idle and 2000 rpms till it warmed up. pulled the radiator bleeder watched the temp needle

Initially there was little to no pressure at the radiator when the engine warmed up it had a bit more pressure but not much, and coolant was never even warm up front. the fan never came on, this is odd to me as it always did

Eventually the temp gauge went to the top and finally the lite began to blink the reservoir did begin to pressurize and the gurgling and bubbling sound began (obvious bubbles where the large hose comes into the top of the tank) never did the coolant at the radiator get warm nor the fan come on.

The plugs on the rh side did have a suspiciously cleaner look, though they are pretty new so ?

I wonder if it is a leaky head gasket if the pressure build up could inhibit the thermostat from opening ? meaning i might have two problems, one minor and the other well, more involved ?

So I guess I should replace the thermostat ( any easy item to deal with) and see if this changes things?

-john

Miguel Pacheco wrote: > John, you don't mention if the radiator cooling fan is coming on. If > things are getting that hot, you should hear the fan come on low > speed,then high. If you pull the radiator bleeder like Benny suggested > (simple things first like David Vickery suggested,) I bet you will not get > hot coolant. So, from how I read things here, unless your rad fan is out, > your thermostat is stuck closed. You can just go in and pull it out, > without putting another one in there, for the sake of troubleshooting, > replace the thermostat housing cap and do another test run. If the fans > come on and you are getting hot liquid to the rad, then presto! Damn, I > hope for your sake that this is it. Good luck. Miguel >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.