No, not THAT thread.... I'm in the rare position of being able to compare the South African towing hitch bumper bracket (no longer available) to the original European version. There are similarities and there are differences. Both consist of a large tube, with long tangs welded on that extend into the rails of the Vanagon frame. On the European version the nuts are welded to the tangs and are the same size as the standard bumper brackets use. There are 3 on each side (6 total.) On the South African, the nuts are held captive in a cage, are nylock nuts and are one size smaller than the standard bumper brackets use. On the European bracket, there is a base with 4 holes that the tow ball attaches. The tow ball bracket uses all 4 bolt holes. The South African has 4 holes as well, but the tow ball only uses two of the holes. The bumper attaches to a welded on portion no the European version. On the South African version the bumper is attached to a separate part that is in turn bolted to the end of the tube. There are (were) different brackets for steel versus fiberglass. I'm not sure the European version supported a fiberglass rear bumper. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.