Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 2007, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 30 Jul 2007 14:00:20 -0700
Reply-To:     Brendan Slevin <brendan@BELLATAZZA.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Brendan Slevin <brendan@BELLATAZZA.COM>
Subject:      Re: Oil
Comments: To: Dennis Haynes <d23haynes57@hotmail.com>
In-Reply-To:  <BAY125-F25118C2FCE28C01E0C7A28A0EE0@phx.gbl>
Content-Type: text/plain; charset="us-ascii"

Awesome! Thanks for your help. 20-50 is what I always used to run in my Peugeot. Totoro has 141k. I'm not trying for the top mark but it always seems down around the bottom mark. I bet that is where it needs to be. Sometimes it will make a loudish valve/lifter sound (wife calls it the lawnmower sound) and I'll check the oil and add a bit and it goes away. Related?

Brendan

-----Original Message----- From: Dennis Haynes [mailto:d23haynes57@hotmail.com] Sent: Monday, July 30, 2007 1:56 PM To: brendan@BELLATAZZA.COM; vanagon@GERRY.VANAGON.COM Subject: RE: Oil

For starters, what level are you trying to keep the oil at? If you are shooting for the top mark, you are really overfilling it and slopping it past the rings. you are also heating it up and splashing it excessively and destroying the catalyst buy putting all that oil into it. It is also possible that the ring design is allowing it to go by. FUN BUS has used oil since new. A quart for every 1 to 2 thousand miles depending on type of driving. Local short trips use the most.

Anyway, the top mark is not the fill mark. It is the maximum, do not exceed no matter what mark. Also, the van needs to be level, including side to side

when checking the oil and sufficient time is needed to allow the oil to drain down from the heads and top of the case. What I do, change oil and filter, fill with 4.5 quarts. Run engine. Let sit for 10 minutes. Check oil level. That is level you want.

Synthetic blend oil is one of those I don't know why things. Most oil contamination comes from the oil itself breaking down. So any conventional makes you do frequent changes. After 250K miles at 7,500 change intervals, go for the good stuff. Also, the Vanagon really needs 20w-50 or the equivalent.

Dennis

>From: Brendan Slevin <brendan@BELLATAZZA.COM> >Reply-To: Brendan Slevin <brendan@BELLATAZZA.COM> >To: vanagon@GERRY.VANAGON.COM >Subject: Oil >Date: Mon, 30 Jul 2007 13:35:55 -0700 > >Maybe I should've asked first, but I changed Totoro's oil about two >weeks/1000 miles ago. I used Castrol synthetic blend10-40w and a fram >filter. It's what I could find on short notice here in Bend. Now I seem >to have added a full quart of oil already. :-( It's a bit worrying. Is >there something about synthetic oil that would cause this or maybe a filter >that is a bit off? I don't see smoke or drips. I am confused. > > >Brendan Slevin >84 GL Totoro >Bend, Oregon >I have measured out my life with coffee spoons. -T.S. Eliot


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.