Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2007, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 4 Aug 2007 06:41:47 -0700
Reply-To:     Evan Mac Donald <macdonald1987@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Evan Mac Donald <macdonald1987@SBCGLOBAL.NET>
Subject:      Re: Auto Trans Governor Seal
In-Reply-To:  <B793DDDF-C8C8-4AA1-90F0-F6B672DD19D8@comcast.net>
Content-Type: text/plain; charset=iso-8859-1

Inspect the seal as you are removing it. It may have deteriorated to the point where it is in pieces, and/or become brittle and hard. Be careful to get all of the pieces out of the seal groove and the cavity in the side of the trans/final drive. Also inspect the steel cover itself. It may have rust perforations. When my trans started to leak at the governor seal, I was surprised to find holes in the cover!

Ron LK Johnson <adhocMedia@COMCAST.NET> wrote: We've owned our '91 for only around 2 months. A week or so after bringing it home, noticed leak spots on the ground. A few forays underneath indicate that the majority of the leak is coming form the Governor cap/seal area.

Is it as easy as I think it is to replace the seal? Pop the wire bale off, remove cap, clean area, replace old o-ring?

I plan to drain the fluid and replace the filter and pan gasket as well.

Is there anything else I should consider doing at this time/ Things to watch out for?

Thank you, Ron Johnson Portland, OR '91 Weekender - Betsy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.