Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (August 2007, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:   Wed, 1 Aug 2007 13:54:06 EDT
Reply-To:   JordanVw@AOL.COM
Sender:   Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:   JordanVw@AOL.COM
Subject:   Re: Yet another rusty propane tanks question...
Comments:   To: zolo@FOXINTERNET.NET
Content-Type:   text/plain; charset="US-ASCII"

zolt..your scaring the isht out of the poor guy.. the ID plate is superficial.. if they look scaly or have alot of rust underneath, i just grind them off and chuck them. Manchester was retarted for affixing the ID plates this way anyway.. ive seen scaly rust under the ID plate but NEVER a hole thru or even a weak spot..

chris

In a message dated 8/1/07 1:48:25 PM Eastern Daylight Time, zolo@FOXINTERNET.NET writes:

> > If that welded on ID plate is bulging too too too much, it is probably done. > Most bad rusting is happening there. If its kind of level still, take the > whole thing out and clean it up and POR 15, and Rustoleum paint it, put new > fill valve, new press. release valve, new regulator and that's it. You > don't need to let the gas out of it for just painting, but for changing the > valves, yes. Take off the regulator and open the valve, while the tank is > in the correct position as it would be in the car. > Once it is empty, you can weld and grind and all. The wall thickness of the > tank is not changing substantially with the usual rust. But under the plate > can be half the thickness. One can weld a new piece in there, but it better > be a good welder who knows what he is doing. > To take out the whole thing as follows; > Take off the stone guard, one bolt&nut each side, 13mm. > Take off the pipes, > 15mm long sockets for the nuts that hold it up. Don't take out the two > inner ones, only make them very loose. Take out the two outside ones only. > Hold the tank before you take out the second one, than lower it nicely. > There is no danger. Its a normal gas tank. > Now, remember, you are working with gas. Some of the fittings are marked > with a notch, that means left hand threaded and they tighten and loosen the > opposite way. Just like on an oxy-acetilene set you find them. Fittings > are tapered and self sealing, but you put on teflon tape. > The whole thing is not a big deal, really. It is only strange the first > time. > Zoltan > > >

************************************** Get a sneak peek of the all-new AOL at http://discover.aol.com/memed/aolcom30tour


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.