Date:         Thu, 2 Aug 2007 11:19:13 -0600
Reply-To:     alfred bagdan <abagdan@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         alfred bagdan <abagdan@SHAW.CA>
Subject:      Re: Anti-Roll bar or stabilizing bar popping out of bushing
Content-type: text/plain; format=flowed; charset=iso-8859-1; reply-type=original

I noticed that the roll bar was popped out of the top rubber bushing on the
drivers side.  After some effort, I managed to get it back in but when
reinstalling the arm, the roll bar keeps popping out again.  It seems that
the roll bar is too short by about one inch or so.
If anyone has had that problem and has a solution, I would appreciate a
reply.

Thanks,

Alfred
85 Westy

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.