Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2007, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 25 Sep 2007 11:06:00 -0700
Reply-To:     courtney hook <courtneyhook@SHAW.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         courtney hook <courtneyhook@SHAW.CA>
Subject:      [WARNING - NOT VIRUS SCANNED] Can we weld new exhaust manifold
              flanges on our heater boxes?
Comments: To: type2@type2.com, wetwesties <wetwesties@yahoogroups.com>
Content-Type: text/plain; charset=us-ascii

My 77 Westy heater box flanges (the triangular shaped ones) are corroding badly, yet the boxes themselves are in very good condition. I was wondering if I could just weld new triangular flanges on where the old ones are? I thought the thickness of plate, added to the old ones wouldn't be much of a consideration in clearance or muffler problems. Any thoughts on this? Thanks, Courtney


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.