Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2007, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 22 Sep 2007 23:14:55 -0700
Reply-To:     Mark Keller <kelphoto@TELUS.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Keller <kelphoto@TELUS.NET>
Subject:      Re: elec window motor
Comments: To: zolo@FOXINTERNET.NET
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Hi Zoltan

I wrote up a complete repair seems to be in the last five years; just search the archives under my kelphoto, should get you close Pmail me with any questions as I'm on digest..

The motor and mech are attached via a plastic and rubber coupling. If memory servers the couple is pretty tough, to get them apart I pry with a couple of thin blades and I spray a solvent, we use Moovit up here but WD or some such penetrating oil, spray with the straw at the shafts where they would exit the motor and or the mechanism. Wait , Pry , spray, repeat... Wigging the two components in a side to side motion and/ or tapping on the actual couple may dislodge it a bit sooner, once you get the flanges apart enough. The shafts are slip fit into the couple about 3/8 inch. So worse case if both end moved the exact amount until letting go you'd be at the 3/4 inch part. It seems that the rubber part of the couple is cast around the two plastic collars , so prying may feel like something is rather elastic.

Mark


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.