Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (September 2007, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 30 Sep 2007 14:15:44 -0400
Reply-To:     Roger Sisler <rogersisler2000@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Roger Sisler <rogersisler2000@YAHOO.COM>
Subject:      Re: Clutch Slave Cylinder
Comments: To: Andrew Meyers <ac.vanagon@GMAIL.COM>

You dont have to know good parts from bad.--- Bus depot does.


Get the master and slave at the same time. About $110. Dont change the
rubber hose that runs from the master cyl resivour. Brake fluid will eat
away at most rubber replacements.


The clutch master cyl looks impossible, but is not difficult at all. The
puxh rod most likely need any adjustment and it a simple swap out. You
need to remove and install the fastening bolts , blind.


You might want to get some recent feedback on bleeding this system,once
installed. Lots of war stories here.
Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.