I recently had the tranny out for my subie swap. It worked fine afterwards, although shifting into 4th was a little hard at first. But it got better over the weeks so i forgot about it. Now I just installed the short shift kit, and there is no way to get into fourth now anymore, at least while standing. So...... I know there can be some difficulties from not getting the shifter base plate into the right spot after installing the short shift kit, but this should typically get you reverse gear trouble i think. So I wonder before I take that part again, whether its just the rear linkage, and the original problem just got amplified with the short shift kit? Any expert advice on where the problem could be - front or rear linkage? And in what direction to shift the linkage? thanks florian |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.