Date: Fri, 12 Oct 2007 18:47:31 +0000
Reply-To: rubatoguy@COMCAST.NET
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Todd Last <rubatoguy@COMCAST.NET>
Subject: Re: Cooling Fan info discrepancies
I have A/C and my fan has 3 speeds. (1988)
If I turn on the A/C compressor, the fan will automatically turn on - but I have not confirmed which speed is comes on at.
Todd
-------------- Original message ----------------------
From: Ben Cichowski <cichowski@MONTANA.EDU>
> Dylan,
>
> Someone please correct me if I'm wrong, but I believe vans without AC have 2
> speeds (low...and high - just before overheating) just like the ones with
> AC. However, I think there is actually a "3rd speed" if you will for those
> with AC that is controlled by turning on the AC switch itself.
>
> Ben
>
>
> On 10/12/07 10:49 AM, "dylan friedman" <insyncro@YAHOO.COM> wrote:
>
> > Do vans without AC have two speeds or just one?
> >
> > curious.
> >
> > dylan
> >
> > Kenneth Wilford <kenwilfy@COMCAST.NET> wrote: Ben, if you are getting both
> > speeds by jumpering the connections at the
> > fan switch plug then your low speed resistor has to be fine.
> >
> > If the fan is coming on when you jumper it at the fan plug that means
> > that the fan itself and all of the wiring, relays, resistor, fuses are
> > good to go. The only thing that can keep it from coming on at this
> > point is the thermoswitch on the radiator. I would get a infrared heat
> > gun and start taking temperature readings. Is the radiator getting hot
> > enough for the thermoswitch to turn the fan on? If it is then the
> > thermoswitch must be having a problem. You should be able to measure
> > across the switch when the temperature is up to see if it completes the
> > circuit at the proper temperature (zero resistance with an ohm meter).
> > So your problem has to be right at the radiator, at the thermoswitch.
> > You can stop hunting further. Determine if it is reaching the proper
> > temperature and then go from there.
> >
> > Hope this helps,
> > Ken Wilford
> > John 3:16
> > www.vanagain.com
> >
> > Ben Cichowski wrote:
> >> Hi All,
> >>
> >> Been reviewing archives for days in hopes of not pestering anyone about my
> >> cooling fan problems, but I'm running into a lot of conflicting info and
> >> want to trouble shoot possible reasons for my cooling fan not kicking on:
> >>
> >> This is for an '88 Vanagon Wolfburg Weekender
> >>
> >> Everything now heats properly (both sides of the radiator get properly hot,
> >> and the thermoswitch is new, so is the water pump, radiator, thermostat) -
> >> there were other problems before this one came up!
> >>
> >> Things that have been RULED OUT or, in some cases, replaced if found to be
> >> bad. (to save time on your responses)
> >> Radiator, Thermoswitch, Thermostat, Fuses, Water Pump, coolant level or
> >> quality, headgasket, cap on coolant tank, bubbles in coolant system (many
> >> good burping sessions with the front end WAY up and my prego wife at the RPM
> >> station).
> >>
> >> 1. I connected the slots on the 3-pin plug for the thermoswitch and I get
> >> both speeds to come on. Question: Does this test rule out problems with the
> >> resistor behind the headlight? - discrepancies in archives here
> >>
> >> 2. Could the relay under the dash be the cause of these problems? Some say
> >> that changing this worked for similar problems, others say that the relay
> >> could not possibly have anything to do with this.
> >>
> >> 3. I changed the ground connectors on the fan itself and behind the dash,
> >> but I'm still leaning towards this all being a problem with wiring. How the
> >> heck do you check for internal breaks in the wires given the length and
> >> tight location? Should I just change out all the wires and see if it works??
> >>
> >> Thank you so much, I know you have all probably written too much on this
> >> already, I'm jus trying to sort through what information is correct.
> >>
> >> Cheers,
> >> Ben
> >>
> >>
> >
|