Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (October 2007, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 18 Oct 2007 11:40:12 -0400
Reply-To:     Geza Polony <gezapolony@SBCGLOBAL.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Geza Polony <gezapolony@SBCGLOBAL.NET>
Subject:      Re: Running rich.....me too
Comments: To: Cecil Eastman <Eastman.C@ATWOODMOBILE.COM>

Cecil,

You're on the right track. The place to start is getting a known-good volt-ohm meter. Then, use your Bentley to do the ECU pin test--you can check every electronic component of the FI system (except the ECU...) from there, including your idle switch.

If the pin test shows everything is ok, move on to vacuum leaks. Fill the engine with air from a compressor and squirt soapy water all over the place (engine not running.)

Got the vacuum leaks done? Check fuel pressure at the test point.

Once you know that's ok, then do the flow test for the injectors per Bentley.

Doing these tests will point out 99% of the causes of running rich. Note that the cost, including buying a fuel pressure gauge and a new VOM from Radio Shack, is less than $100.00. And just think of the fun you'll have!

Another freebie you might try. There's a little green wire that goes from your ECU to your O2 sensor. It has a coaxial ground on it that sometimes gets messed up and contacts the hot wire from the sensor. If this is the case, it will eliminate or severely screw up the signal to the ECU, which in turn will make the van run crappy (and rich). This defect WILL show up in the pin test described above, but you might want to just take a look at it as it's such a common failure point. Even one tiny strand of that coax will mess things up big time.

The one electronic FI component you can't test very well with your VOM is the AFM. Do everything else first, then, when you know it's all good, take your van to a good mechanic with a sniffer. To set the AFM takes about 30 minutes or $50 of shop time. Make sure they set it both at idle and at speed, like 2500 RPM.

There are other things that can go wrong, but I think this covers most of it.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.