Date: Fri, 26 Oct 2007 11:04:14 -0700
Reply-To: Jake de Villiers <crescentbeachguitar@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Jake de Villiers <crescentbeachguitar@GMAIL.COM>
Subject: Re: Would like some advice, re: clutch release bearing
In-Reply-To: <4722198D.7050907@gmail.com>
Content-Type: text/plain; charset=ISO-8859-1
It should be fine John, especially if you're planning to replace it in a
year. As long as its been working quietly and smoothly it's good. Does it
spin nicely with your fingers? Okay.
I would make sure that the release fork pivots are lubricated and
free-moving and put it all back together.
Seeya, Jake
On 10/26/07, vanagonvw <ac.vanagon@gmail.com> wrote:
>
> I have the Bentley and a Clymer manual. Bentley shows great details, but
> gives little info on 'how to' The clymer offers some how-to, but
> incredibly, when it comes to the release bearing, it refers to pictures
> that are not in the book :-)
>
> Mine is an 81 air cooled. The clutch and bearing were replaced about 25K
> miles or so ago and have shown no indications of any issues. Yesterday,
> I took the engine out for head replacements, and since its sitting
> right there staring at me, I figure its time well spent to take a look
> at the bearing. I am reticent to play with anything that is working
> fine, so I seek advice as to what to look for, how to possibly remove
> the bearing for inspection if that is deemed necessary, and what kind of
> lube and/or cleaning to perform on it, or on the input shaft. Bits and
> pieces of manuals declare "do not grease" parts of the assembly, so I
> just want to be sure what is right and what is wrong.
>
> Its been two decades since I was tearing apart motors and transmissions,
> and even then, none of them was a VW, so I am hoping there may be some
> writeups, or pictures on a link somewhere, and maybe someone can share
> what they know about inspecting the parts.
>
> Please note that if I could afford it, I would just replace the bearing
> and call it good, but that is not an option, as the van's budget is
> already over the top with a new clutch slave cylinder and CV boot on top
> of the head replacement.
>
> If I have my way, I will be able to do a Boston Bob or some other new
> engine in about a year, and I am confident that if I don't mess up the
> bearing by checking it out, it will be fine until then.
>
> Any advice or suggestion would be gratefully accepted.
>
> Thanks a lot,
>
> John
>
--
Jake
1984 Vanagon GL
1986 Westy Weekender "Dixie"
www.crescentbeachguitar.com
http://subyjake.googlepages.com/
|