That's very useful info- about the tach. Since the tach is ignition system driven......work on that system thoroughly. Personally, I'd just pop on another known-good distributor ...as a test, and be really picky about wiring and the wiring harness. Also 'coil' - I consider coils to be 'nebulous'....they don't fail in a black & white way ...they just get funky/weird eventually. If you have a 20+ year old coil, I'd put a new one on there in any case, or possibly a known-good used one. I do not like coils with many years and a bazillion miles on them when there is any weirdness with the ignition system. Also, ALL ground connections - the importance of those can not be overemphasized. Scott www.turbovans.com -----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of TJ Hemrick Sent: Tuesday, October 30, 2007 6:52 AM To: vanagon@GERRY.VANAGON.COM Subject: New symptoms (still not running right)

A week or so ago, I posted about my 87 running very rough except at highway speeds. Most replies concerned looking over all my connections since I had just given the engine a lot of new parts and service. No problems noted there. Dennis Haynes noted that any conditions that start out fine and then go bad most likely lead to an O2 sensor. OK, I have to cut and drill mine out as it's jammed in so bad. Only problem is, sometimes the van runs fine and sometimes, it starts of really bad and/or has a LOT of trouble starting/restarting. Anyhow, here's a new thing that may tip some of you more experienced than I into where I might need to look. The other day I start it up and about 2-3 minutes into it, my tach goes crazy. The engine is loping at an idle but the tack is at 3-4K and moving around 1K or so. I goose the throttle and the needle responds but it goes right back to the 3-4K range and hunts. The whole time (except for goosing) the engine is idling. I take off and drive normal but the needle is staying in the 3-4 range. After about 5 minutes, it works normal. Haven't driven it since then (3-4 days). It still sputters and hesitates really bad. It stalled on me right smack in the middle of a busy intersection and would not restart. Had to get pushed over to side. It finally started about 2 minutes later. How is it that it runs fine at highway speeds and like crap around town? BTW, 3 different AFM's all the same problem. New cap, rotor, wires (double checked the order), plugs, air filter, and cleaned the AFM. Not gas quality as I've pumped about 15-20 tanks from different stations since this started.

Confused in FL

TJ