Date:         Mon, 5 Nov 2007 12:20:58 -0500
Reply-To:     Kai Mei <kai@NEWCLEAR.US>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Kai Mei <kai@NEWCLEAR.US>
Subject:      Clutch job... done properly
In-Reply-To:  <C354896B.2576%cichowski@montana.edu>
Content-type: text/plain; charset=US-ASCII; delsp=yes; format=flowed

I'm about to have the rear main seal, throwout bearing, plate, pilot
bearing, pressure plate, flywheel o-ring and felt ring done on my 87
Wolfie.

Is checking the crank endplay common among average VW mechanics?
There's a bit of a language barrier here.

Anything else that should be done simultaneously? The slave cyl,
looks to have been of a more recent vintage as opposed to never been
touched...

Thanks everyone.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.