Date: Sun, 11 Nov 2007 17:22:01 -0500
Reply-To: Benny boy <huotb@VIDEOTRON.CA>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: Benny boy <huotb@VIDEOTRON.CA>
Subject: Re: Water pump premature failure
Everything is pretty straight foward around that pulley.
Was that pulley "out of whack" when you got the van/engine? did you ever
notice? if something as just started lately, that big bolt is loose, if not,
it as been like that for a wile and you never noticed!
There is no way that pulley will go bad if nothing happen.
If it as been like that for a wile, it was simply wrongly installed, it was
force in and the key/groove were not align properly, to do so, you must be
drunk :-) There is nothing to it, align pulley, bolt it in. I never use a
torque wrench, i always use my impact gun for this one. As to belt, again,
there is nothing there. just leave some loose, i mean you should be able to
move this one up and down about 1/2 in, or better, you should be able to
twist this one 180deg (even more) EASILY.
No, if that pulley is really offset, go see a mechanic before this one spin
out an/or break the cranshaft!!! i have seen that happen, not pretty.
Ben
On Sun, 11 Nov 2007 12:47:38 -0500, Geza Polony <gezapolony@SBCGLOBAL.NET>
wrote:
>It's those "nasty belt oscillations" that I'm worried about. This is
>definitely a 3-groove pulley, and it's definitely out of whack, at least
>horizontally. I certainly have never removed the pulley on this VWoC
>remanufactured engine, but maybe the PO did for some reason. It doesn't look
>like the kind of thing you'd do for fun.
>
>I'll try tightening the belt down some more but I've always been afraid of
>killing the bearings that way. Both Bentley and Haynes are near useless on
>this point: the belt is supposed to deflect 10-15mm when pressing "firmly"
>with thumb, but what does "firmly" mean? Arnold says one thing, Maria
>another. Vast difference.
>
>Yeah, this is a primitive design, with the alt/wp belt contacting maybe 20%
>of the drive pulley. It seems like to make it work you have to tighten the
>belts way more than you would with greater contact surface, leading
>to...premature bearing failure. I bet some ingenious guy could come up with
>an idler system that would help us out. Any takers?
|