Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2007, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 21 Nov 2007 15:51:18 -0900
Reply-To:     Troy <colorworks@GCI.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Troy <colorworks@GCI.NET>
Subject:      Propane fitting thread compound
Content-Type: text/plain; charset=iso-8859-1

Hi folks:

Have a question about assembling of the threaded portion of brass propane fittings. I just purchased a Stay-a-while also known as the extend-a-stay, and I'm having to change some of the fittings into a different configuration. It appears to me that the manufacturer used the red (permanent) loctite thread lock compound. I'm just curious if this is the stuff to use for reassembly, or should I be using the white Teflon paste? Can't imagine the fittings vibrating loose overtime. Is one type of thread compound preferred over the other for propane?

Thx,

Troy


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.