Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (November 2007, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 15 Nov 2007 22:13:23 -0500
Reply-To:     ***************** <vw4x4@VERIZON.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         ***************** <vw4x4@VERIZON.NET>
Subject:      Re: Earl Scheib paint job
In-Reply-To:  <AF3DEABF-5EB3-4500-B1CF-B9CE1928B45D@pottsfamily.ca>
Content-type: text/plain; charset=ISO-8859-1; format=flowed

With any purchased paint job today, the first thing I would ask is, are they using a base coat/clear coat paint? If not run. Your better off with a can and a brush, like the corvair guy. I've painted several vehicles. The cost of materials today is outragous. With these prices that are being quoted, I'm not sure what they are using....

Greg Potts wrote:

> Hi Geza, > > I got good results from Maaco in 2001. Paid about the same as you > were quoted. I did all my own prep work, and had to have the bus > towed there and back since the windshield was out. I went with the > mid-grade paint. > > The end result was very nice, though the red is starting to "pink > out" a little bit now. But considering it's been stored outdoors for > the past 6.5 years, I think it's a good value for money. > > PLEASE NOTE: Results when dealing with franchise operations will vary > immensely from branch to branch. Be sure to check out their work > beforehand and get references if possible. > > Happy Trails, > > Greg Potts > 1973/74/77/79 Westfakia "Bob The Tomato > www.pottsfamily.ca > www.busesofthecorn.com > > > > On 15-Nov-07, at 8:08 PM, Geza Polony wrote: > >> OK, I'm considering an Earl Scheib paint job. Before you pile all >> over me, >> consider this: the van has rust "issues," as in holes you can put your >> finger through, and it will never be perfect. It's also a camping >> vehicle >> and that means I don't want to worry about the finish too much as I >> think it >> would take away from the fun of camping to have to do so. >> >> I got an Earl Scheib job done decades ago and it was terrible. You >> could see >> this poor Volvo with "repaint" written all over it for about a >> block away. >> The question, then: >> >> Has anybody used Earl Scheib recently? Has the quality improved? >> Anything >> close to factory colors? >> >> FYI, They will spray the van for $399 plus tax, adding $50 a jamb/ >> door if I >> want them done. I can take off all the easy stuff like turn signals >> and >> they'll mask the rest. Sounds like if I do the bondo I'll be paying >> under $700. >> >> Spray it again, Sam. It's that time again. > >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.