A little bit of Teflon paste will lubricate the threads. Don't use tape, because it can shred and small pieces can plug up fine gas orifices. Jerry ----- Original Message ----- From: "Troy" <colorworks@GCI.NET> To: <vanagon@GERRY.VANAGON.COM> Sent: Wednesday, November 21, 2007 5:51 PM Subject: Propane fitting thread compound
> Hi folks: > > Have a question about assembling of the threaded portion of brass propane fittings. I just purchased a Stay-a-while also known as the extend-a-stay, and I'm having to change some of the fittings into a different configuration. It appears to me that the manufacturer used the red (permanent) loctite thread lock compound. I'm just curious if this is the stuff to use for reassembly, or should I be using the white Teflon paste? Can't imagine the fittings vibrating loose overtime. Is one type of thread compound preferred over the other for propane? > > Thx, > > Troy > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.503 / Virus Database: 269.16.4/1145 - Release Date: 11/22/07 11:49 AM > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.