Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 2007, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 27 Nov 2007 16:32:07 -0800
Reply-To:     neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil N <musomuso@GMAIL.COM>
Subject:      Re: Ignition switch replacement Experience?
Comments: To: Jerry Baker <jbvelo@bellsouth.net>
In-Reply-To:  <vanagon%2007112719052823@GERRY.VANAGON.COM>
Content-Type: text/plain; charset=ISO-8859-1

I second this motion! Not a tough job. I didn't use this particular web page, (I'm sure it's a good tutorial) but can say that in general the "shortcut" works and saves time. Although I tend to carry too many spare parts, IMHO, a spare ignition switch is not a bad thing to keep in the bus. Pretty cheap item.

Neil.

On Nov 27, 2007 4:05 PM, Jerry Baker <jbvelo@bellsouth.net> wrote:

> Mark, > See attached link. This is a DIY job. It does take > a little patients and time but it's not complicated. > I replaced my switch about a year ago because my headlights > quit working. There are some shortcuts to the procedure > listed on the website. It's been so long ago I can't > remember the shortcuts. If I think of them I'll let you > know. Basically the lock cylinder has to be removed to gain > access to the ignition switch. The ignition switch is > attached to the lock cylinder with one screw on the inside of > the cylinder. > > http://carboncow.net/vanagon/projects/ignition_switch.htm > > Good luck > JB > KY88GL > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of > Mark Keller > Sent: Tuesday, November 27, 2007 11:42 AM > To: vanagon@GERRY.VANAGON.COM > Subject: Ignition switch replacement Experience? > > HI, > > I had a start but no run the other day.. I had to "hold" the key in the > run position, and got home. So I've got the new switch and I'm looking > at the Bently for doing the replacement of the ignition switch. Is this > a diy?, I pulled the colum down and have had a look, but I'm not sure > whether to delve into it. Anyone have comments. I'm on digest, and I > can't seem to get on to the archives. So Pmail is appreciate. > > Mark >

-- Neil Nicholson. 1981 Air Cooled Westfalia - "Jaco" (Bustorius) http://web.mac.com/tubaneil

Engine swap beginings: http://musomuso.googlepages.com/home


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.