A glow plug is just an electrical resistor. Imagine a very heavy duty light bulb without the glass globe. When you pass electricity through it, it heats up. To check, remove the bolts holding the electric wire to the glow plugs. Put an ohmmeter between the terminal (where the wire was) and the engine block. If you get an open circuit (infinite resistance), the glow plug's filament (like a light bulb) is broken and the plug needs to be replaced. If you get a number like 10 or 30 ohms, (in that range- don't know exactly what it should be) the glow plug is OK. The very first check of the system is to check for voltage at the glow plugs for a few seconds when you turn the key to "on" and the glow plug light goes on.
tabe johnson/87 westy |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.