Date: Sun, 2 Dec 2007 20:44:57 -0500
Reply-To: robert feller <syncro.carboncow@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: robert feller <syncro.carboncow@GMAIL.COM>
Subject: Re: New thermostat funky?
In-Reply-To: <010101c8354b$b4064bf0$6701a8c0@TOSHIBALAP>
Content-Type: text/plain; charset=ISO-8859-1
I respect Scott's comment but i will decent on this one.
We went the 100% crazy route when we thought my gauge was reading high (7/8)
and sometimes red light on warm days. New sensor, stat, radiator, wiring
check, voltage stabilizer/reguator ect. Finally got the infered gun and
compared locations and temps to my buddies 2.1L and we took exact temp
readings but our gauges showed different data. it's hard to say what is
"dead on" with these gauges. I did tons of research with Bentley, VDO and VW
tech manuals trying to figure out all Ohm readings for a given temp. Lot of
work and poor data out there to find that different resources gave slightly
different Ohm readings for arbitrary gauge readings. I've got the sources
for those interested.
Combine this to a gauge that reacts wide and slow due to the radiator being
so far forward and I've never been a huge fan of the temp gauge on these
things for the often OVERCOOLED vanagon engine.
Shawn
On Dec 2, 2007 8:27 PM, Scott Daniel - Shazam <scottdaniel@turbovans.com>
wrote:
> Hi,
>
> I consider the vanagon temp gauge to be one of the very best there is in
> the
> car world ( not counting the sometimes over active level sensor function
> )
> .
>
> I find them to be dead accurate. ( voltage stabilizer in the dash has to
> be healthy of course )
>
> Just verify with a infrared temp gun right where the temp sensor is on the
> engine.
>
> Straight up on the LED is 180 degrees F, or darn close to it.
>
> Cooler is not better, warmer is.
>
> But run however you like.
>
> Going by the heater output is not a reliable way to judge actual running
> temp.
>
>
>
> Here's a fun one - on an OBD-II subaru engine, you can hook up your
> diagnostic program, and see exactly what temp the ECU temp sensor is
> seeing,
> right to the very degree. I like that.
>
>
>
> -----Original Message-----
> From: Vdub Guy [mailto:fonman4277@comcast.net]
> Sent: Sunday, December 02, 2007 5:11 PM
> To: Scott Daniel - Shazam
> Subject: RE: New thermostat funky?
>
>
>
> If your temp gauge is calibrated and working correctly,
> Anything well below the LED is much too cool running.
> I strive for just to the right edge of the LED
>
>
>
>
>
>
>
> Hi Scott,
>
> At first, when I put this engine together, I thought the thermostat
> was
> stuck open. On Jim Thompson's recommendation I used the colder t-stat. The
> heater has always put out plenty of heat. I figured too that the gauge
> might
> not reading accurate either. Jeff
>
|