Don't cut holes! you drive a roll pin out between the seat and armrest. Once you have the armrest off, you remove the two screws that hold the post on, loctite them, the re-attache the post, put the armrest back, drive the pin back in. Robert 1982 Westfalia
--- Jeff Michal <jeffmichal@YAHOO.COM> wrote: > Volks, > > My drivers seat right side armrest in my 90GL > has gotten loose and is dangling straight down > now.. How can I fix it? I think it just came > loose, and I need to tighten something up. My > instinct is to cut a hole in the vinyl over the > axel on the armrest to access the bolt I can > only assume is in there. Is this the right > choice? Perhaps I have missed something? Any > tips appreciated. > > Thanks, > > Jeff > 90 GL > > > > ____________________________________________________________________________________ > Be a better friend, newshound, and > know-it-all with Yahoo! Mobile. Try it now. > http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ >
____________________________________________________________________________________ Never miss a thing. Make Yahoo your home page. http://www.yahoo.com/r/hs |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.