You need Robert Keezer, he's The Gas Heater Man! Not far away either, near Seattle. On Dec 9, 2007 4:16 PM, Courtney Hook <courtneyhook@shaw.ca> wrote: > OK, I've got two B2 Eber. gas heaters here, and the thermoswitch/quarz > sensor rods are NOT coming out without shearing the top off the inner > chamber threaded connection, (in fact I've already done this with one, so I > suspect the heater is instant junk). They are SO delicate here, yet it > requires their removal to service the switch. VERY poor design. After 30 > yrs, the nuts are so siezed on I would say your are NOT going to get them > seperated from the inner chamber threaded male fitting. If anyone knows who > can service and hopefully repair my little learning experience I would > appreciate it. > Thanks, > Courtney >
-- Jake 1984 Vanagon GL 1986 Westy Weekender "Dixie" Crescent Beach, BC www.crescentbeachguitar.com http://subyjake.googlepages.com/ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.