Date:         Sat, 15 Dec 2007 09:51:00 -0800
Reply-To:     neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil N <musomuso@GMAIL.COM>
Subject:      KMS Tools. Great place - (and I got my MIG welder!) (LVC)
Content-Type: text/plain; charset=ISO-8859-1

Hi all.
Just got my Hobart Handler 140 MIG welder from KMS. - WooHoo! When I have
time, (and run a new circuit) I look forward to practicing drawing beads in
prep for making the engine support for Jetta into my Westy. (VC)

Can't say enough good things about KMS in Coquitlam and the people there (at
least in the Welding dept.)

Quite likely most locals (Vancouver B.C.) have been to this place, but for
those who haven't, or for out-of-towners, check it out.

There is a *lot* of stuff there to look at, decent amount of parking and
very helpful staff.

If you're ever looking for a new (or used) tool or supplies, go there first.
I had been looking for the 1 1/16" Pittman arm puller at local FLAPS places.
I found both the 1 1/16" and 1 15/16 Pittman arm pullers at KMS.

Not affiliated with KMS. Just excited about new purchase, and sending out a
recommend.

Cheers,

Neil.




--
Neil Nicholson. 1981 Air Cooled Westfalia -
"Jaco"  (Bustorius) http://web.mac.com/tubaneil

Engine swap beginings: http://tubaneil.googlepages.com/