Date:         Sun, 23 Dec 2007 14:11:47 -0800
Reply-To:     Scott Daniel - Shazam <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Shazam <scottdaniel@TURBOVANS.COM>
Subject:      Re: Clunking sound
Comments: To: Dvdclarksn@AOL.COM
In-Reply-To:  <c89.1e69a8d2.34a02345@aol.com>
Content-Type: text/plain; charset="us-ascii"

David, if you noise is associate with bumps, I've found lower front shock
mounting bolts not tight enough a few times, causing that symptom.  They
need to be really really tight.  Like 80 ft. lbs. - I don't know what
Bentley says, but I can tell you the lower front shock mounting bolts really
need to be creamed down.
Scott 

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
David Clarkson
Sent: Sunday, December 23, 2007 12:47 PM
To: vanagon@GERRY.VANAGON.COM
Subject: Re: Clunking sound

I had the exact same symptom and replaced the CV joints, transmission (for
other reasons) and rear wheel bearings and nothing has changed. I have been
living with the noise for 50k or more and think that I will look at the
trailing
 arm bushings since my problem is worse at slow speeds going over bumps. I
have  also replaced all of the shocks/struts as well. The noise does sound
like
a CV  joint noise but I even swapped out both sides after replacing with new
joints  just to absolutely rule out getting a bad joint in the same place.

David Clarkson
90 Westy (245k)



**************************************See AOL's top rated recipes
(http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)