Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (January 2008, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 8 Jan 2008 14:33:50 -0800
Reply-To:     Michael Sullivan <sandwichhead@YAHOO.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Michael Sullivan <sandwichhead@YAHOO.COM>
Subject:      Oil Cooler and Bleeding
Content-Type: text/plain; charset=iso-8859-1

Just got my hoses from http://www.bus-boys.com/index.htm and gonna put them in. Pretty easy job, but wanted to bleed system due to loss while removing the cooler. Wanted to clarify: 15% angle(front up) and warm up w/heater. Bleed front till no air and top off in rear? Any idea(no torque wrench, my kid borrowed) how tight the retainer nut goes on the cooler?It's about 27mm or 30mm Thnaks, Michael 91GL'Gringo'.

Thanks, Michael Sullivan


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.