Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2008, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 12 Feb 2008 14:04:03 -0500
Reply-To:     David Milo <dellaone@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Milo <dellaone@GMAIL.COM>
Subject:      Re: Frozen accelarator cable?
Comments: To: Edward Duntz <eduntz@hotmail.com>
In-Reply-To:  <BAY134-W1004054FB2F640B035C77FDB2B0@phx.gbl>
Content-Type: text/plain; charset=ISO-8859-1

Hi Ed,

You live in balmy Connecticut, right?

It has been my experience that the black colored flexible throttle cable sheath under the van near the right rear wheel area is what becomes internally moisture laden and then freezes the cable in place. Usually after it starts getting moisture in it, it rusts the inner steel casing, as there is a low spot there. The resulting "swelling" of the sheath can make the throttle action stiff in warm weather, and impossible if any water in it freezes.

Try heating up the low spot in the cable sheath, and then try to get some WD down inside it. I have found that the only permanent fix (for me) is to replace the cable and sheath.

Good Luck,

Dave

On Feb 12, 2008 11:37 AM, Edward Duntz <eduntz@hotmail.com> wrote:

> Thanks for the suggestions so far. I thought I had solved the problem, > cleaned and lubed everything that could be causing me trouble, but then it > happened again. The pedal itself moves up and down when you move it by hand, > but does not return to the up position and you can't pull the cable back at > the engine. Right now I've got a heater in the van and a light for warmth > aimed up at the cover over the linkage. > > The plastic cover over the linkage underneath looks like there is a piece > missing at the top so water could get in, but I didn't see any there. > > When I get home I'm going to try shooting some WD-40 down the cable sheath > at the back end until it comes out the other side. > > But nothing really looked frozen. I wonder if it was something mechanical, > i.e. metal sticking to metal and locked up rather than freezing, and it > was just a coincidence that warming it helped. > > Any other ideas? > > Thanks, > Ed > _________________________________________________________________ > Helping your favorite cause is as easy as instant messaging. You IM, we > give. > http://im.live.com/Messenger/IM/Home/?source=text_hotmail_join


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.