Date:         Mon, 18 Feb 2008 09:30:30 -0700
Reply-To:     Larry Himli <lhimli@AOL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Larry Himli <lhimli@AOL.COM>
Subject:      Re: Seam Rust
Comments: To: JordanVw@aol.com
Content-Type: Text/Plain; charset="us-ascii"

I understand, almost everything is in the archives.  However, I just was
looking for recommended undercoating not the procedures.

 

Thanks for responding 

Larry

 

-------Original Message-------

 

From: JordanVw@aol.com

Date: 2/18/2008 9:15:15 AM

To: Lhimli@aol.com; vanagon@GERRY.VANAGON.COM

Subject: Re: Seam Rust

 

In a message dated 2/18/08 11:11:01 AM Eastern Standard Time, lhimli@AOL.COM
writes:







After procrastinating for too long I finally decided to tackle the seam rust

problem.  I have been purchasing materials for some time and the rust was

only getting worse.  So, I started cleaning out the seams from the exterior

painted side.  Then I realized that the problem has to be from damaged or

worn undercoating.  What do you recommend for recoating all affected areas? 

I remember using spray stuff 30 years ago without good results.  I would

think there must be a good quality brush on material.  Thanks.







Larry









larry, did you try to search the archives?   there is an incredible amount
of good info in there on vanagon seam rust.



kinda pointless to type it all out again when you could just go there and
see it all :<)



chris





**************

Ideas to please picky eaters. Watch video on AOL Living.

(http://living.aol
com/video/how-to-please-your-picky-eater/rachel-campos-duffy/2050827?NCID=aol
mp00300000002598)