Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2008, week 3)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 21 Feb 2008 10:37:56 EST
Reply-To:     JordanVw@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         JordanVw@AOL.COM
Subject:      Re: Questions about putting westy cabinets into non-westy syncro
Comments: To: subyvanagon@HOTMAIL.COM
Content-Type: text/plain; charset="US-ASCII"

dave, i will pmail you with my number and you can call me...i can answer this all easier on the phone rather than typing a 5 page report :<)

chris

In a message dated 2/20/08 8:19:44 PM Eastern Standard Time, subyvanagon@HOTMAIL.COM writes:

> > I just got an 86' syncro and a totaled 86' westy. I would like to put the > westy cabinets and curtian rails into the syncro. I have searched the > archives but still have a few questions. > > I will try to be as clear as possible. > > NOTE: I am not going to transfer the pop-top to this van, it will be > transfered to another van. > > (I am going to go the easy route and only cut the hole were the sun roof > would be. My goal is to have standing and storage room, not to make another > bed.) > > 1. I assume the rear clothes closet will fit without any problems since the > roof is higher in a non-westy due to its curvature. Is this a correct > assumption? > > 2. For mounting the cabinets I plan to just use the original sheet metal > screws but I am concerned about the front bracket of the rear clothes closet, > since the syncro gas tank is underneath where the bracket is secured. Is there > enough clearence to just use the origninal sheet metal screws? > > 3. Also the rear seat brackets are screwed into welded on metal tabs that I > do not want to transfer over. I would like to just use sheet metal screws > but again I am concerned about the clearence of the syncro gas tank. (I am > talking about the ones behind the seat, the ones inside the seat should not > interfer with the gas tank) > > 4. What about the curtian rails? How can I mount them without the hole for > the poptop? > > 5. Can I transfer the westy floor to the syncro? > > 6. How do I remove the swivel seats? Are they welded on? > > > Thanks, > David Hines >

************** Ideas to please picky eaters. Watch video on AOL Living.

(http://living.aol.com/video/how-to-please-your-picky-eater/rachel-campos-duffy/ 2050827?NCID=aolcmp00300000002598)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.