Hi Jim Check this out: http://www.van-cafe.com/vanagonparts.jsp?pa=ip&ip=1150562894 I had the same question. It helped me (sorry can't recall for sure it bevelled end faces outboard towards wheel....... Seems to me it does though)
Cheers,
Neil. On Thu, Feb 28, 2008 at 6:19 PM, Jim Felder <jim.felder@gmail.com> wrote: > I went through the horror recently of replacing all my CV joints with new > ones---from china. At least they were free, that's the only good thing about > them. But they are still junk, so I have rebuilt my originals except the one > I had to replace altogether. > The chinese ones don't have any indication of direction, so they are no help > to look at. But the OEM ones have an embossed side of the center hub (a > raised area) and a flat side. > > Which goes in/out? > > Thanks, > > Jim >
-- Neil Nicholson. 1981 Air Cooled Westfalia - "Jaco" http://web.mac.com/tubaneil http://tubaneil.googlepages.com/ |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.