Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (February 2008, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 25 Feb 2008 06:30:26 EST
Reply-To:     FrankGRUN@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Frank Grunthaner <FrankGRUN@AOL.COM>
Subject:      Re:      Oil Temps and TDi rp
              m
Comments: To: sfcompost@YAHOO.COM
Content-Type: text/plain; charset="ISO-8859-1"

In a message dated 2/25/08 12:34:05 AM, sfcompost@YAHOO.COM writes:

> Frank, thanks for the treatise on engine longevity and such.  Certainly not > what most of us feel or assume is the reality when it comes to taking care > of an engine. My question though, is about oil temps. I realize that you have > make serious upgrades to the oil cooling system on your van. From what I read > and hear from others is that the tdi oil temps climb rapidly over 3200 rpm.  > Is this your experience as well, and if so, running the tdi at those high > revs sounds a bit dicey. Oil coolers and DK trans here I come. > Sam M. > > Sam,

Heat is definitely the enemy of diesel engine longevity. I have emphasized in the past that engine oil temperatures are a critical issue and to that end, I only use a top quality diesel grade synthetic (Mobil 1Turbo Diesel Truck 5W-40). I use dual Passat water/oil heat exchangers (often called coolers) and an external Audi 5000T oil cooler fan driven. I also use the auxiliary water pump as per the JX plumbing diagram. I also use a one quart Accusump oil reservoir to buffer possible dry starts and low oil pressure points. Finally, I use the VW ABA windage tray along with a baffle plate to minimize sloshing. In the current design, this baffle plate is made of 0.080 inch Aluminum riveted to the existing vertical baffle cast into the vanagon diesel pan. This is a large immersed thermal surface and probably contributes to oil cooling.

Gauges are an important part of my approach. I monitor the oil temperature exiting the pump and entering the dual oil filter system. For diagnostics, I often monitor the oil leaving the external cooler. Finally, I monitor the EGT with a probe placed in the former EGR port of the ALH VNT Turbo manifold. This gives me the exhaust gas temperature immediately before the entrance to the turbo and at a common flow point from each cylinder. I also use a boost pressure gauge and an oil pressure gauge.

For oil temperatures, I quickly warm up to 190 to 195 F. My typical freeway oil temperatures are between 210 and 220 F. On a hard run, I will see a maximum of 225 F. Running at 4000 rpm on a level road, I initially see (in the acceleration to 4000 rpm, temps quickly go from 190 to 210, then drop back to 200-205. Steady runs at 4500 rpm in the summer with A/C on can bring temperatures up to a max of 230 F. On my Speedhut oil temp gauge, I have the emergency checkpoint trigger at 235 F. These synthetics are rated for full film strength at temperatures above 250 F for extended multihour operation. No particular temp surge is seen going above 3200 rpm. In fact the oil temperature and EGT track each other very well. Oil temperature and EGT are maximized with full load. Low load, low baseline T.

Of course, I have no idea about what are the most critical or necessary parts of my system to give these results. Your results will surely vary.

Frank Grunthaner

************** Ideas to please picky eaters. Watch video on AOL Living. (http://living.aol.com/video/how-to-please-your-picky-eater/rachel-campos-duffy/ 2050827?NCID=aolcmp00300000002598)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.