Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 2008, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 25 Feb 2008 14:56:17 -0800
Reply-To:     neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil N <musomuso@GMAIL.COM>
Subject:      Re: California Imports Bus Shift Rod Bushing Kit?
Comments: To: Scott Daniel - Shazam <scottdaniel@turbovans.com>
In-Reply-To:  <028f01c87800$f29010c0$6501a8c0@TOSHIBALAP>
Content-Type: text/plain; charset=ISO-8859-1

Thanks Scott.

Yah I'm not certain the kit contains all the correct parts.

The "Center shift rod bushing" that's in my Vanagon currently works. Just thought I'd pop in a new one while gas tank is out.

I'll lube it up, leave it in, and wait until I have to do the crossover lines again. Like in more than several years I hope!

In the meantime, I'll order a kit from an actual Vanagon vendor that sells a kit with *all* the right parts.

Thanks,

Neil.

On Mon, Feb 25, 2008 at 2:51 PM, Scott Daniel - Shazam <scottdaniel@turbovans.com> wrote: > Most likely it should say 1980 to 82. > > The support bushing above the approximate middle of your fuel tank is not > fitted in 83 and up vanagons. > The support bushing those use is bolted to a 'frame member' at the aft > edge of the fuel tank. > Scott > Turbovans > > > > -----Original Message----- > From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of > neil N > Sent: Monday, February 25, 2008 11:07 AM > To: vanagon@GERRY.VANAGON.COM > Subject: California Imports Bus Shift Rod Bushing Kit? > > Hi all. > > Anyone used this kit with success? > > http://www.cip1.ca/ProductDetails.asp?ProductCode=VWC%2D211%2D711%2D211 > > I've pretty much confirmed there is a typo, but this kit says: 90-92 > Vanagon. Likely should read "80-92". > > I'm replacing the center shift rod bushing on my '81 air cooled. > > Thanks, > > Neil. > > -- > Neil Nicholson. 1981 Air Cooled Westfalia - "Jaco" > > http://web.mac.com/tubaneil > http://tubaneil.googlepages.com/ > >

-- Neil Nicholson. 1981 Air Cooled Westfalia - "Jaco"

http://web.mac.com/tubaneil http://tubaneil.googlepages.com/


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.