Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 2008, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 8 Mar 2008 11:49:57 EST
Reply-To:     Dvdclarksn@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         David Clarkson <Dvdclarksn@AOL.COM>
Subject:      Re: Replacing Fuel Lines
Comments: To: slloth@COMCAST.NET
Content-Type: text/plain; charset="US-ASCII"

Several vendors have kits available for this. I replaced my lines when the tank started to leak from the gaskets around the cross-over vent lines. I went with the fuel line from Bus Depot since it was reasonably priced and the same kind that was original on my 90 Westy (Conte-I believe was the brand) I was pleasantly surprised when examining the old fuel lines that they had held up and looked almost like new after almost 17 yrs. and 250K. That was reason enough for me to want the OEM fuel line. Be careful removing the old hose and re-installing the new hose on the plastic piece that goes through the firewall. Some have opted to run the new line right through this hole without this piece using a grommet to protect the line from abrasion. Be sure to replace all of your hose clamps and use fuel line clamps so you don't cut into the new fuel line. I found that you will need to re-tighten the clamps around the injectors and fuel rail a couple of times after the first few times you run the engine. It's also a good time to check over the fuel tank and all of the vent lines and gaskets. I replaced everything here too. Also a good time to replace your fuel sending unit if its old and original. Ben has some good pictures and explanations of this job on his web site. Plenty of info on this subject if you search the archives too. I also checked over everything at the same time with the evap canister and valve. My charcoal had all become compressed and wasn't allowing the tank to vent properly (thunk sound after shutting off the engine as the tank depressurizes). I removed the canister and gave it a few gentle thumps until everything in there moved around again and air passed through it. If this doesn't work you probably need a new canister. Good luck and remember to be careful with any incandescent shop lights (breaking) and cell phones (turn off) with all the fumes and possibility of a spark.

David Clarkson 90 Westy 248k

**************It's Tax Time! Get tips, forms, and advice on AOL Money & Finance. (http://money.aol.com/tax?NCID=aolprf00030000000001)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.