Date:         Wed, 19 Mar 2008 12:29:53 -0700
Reply-To:     Scott Daniel - Shazam <scottdaniel@TURBOVANS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Scott Daniel - Shazam <scottdaniel@TURBOVANS.COM>
Subject:      Re: Cleaning head stud threads question
Comments: To: "Giasson, Pascal (DNR/MRN)" <Pascal.Giasson@GNB.CA>
In-Reply-To:  <A817922C9DAF504580C0D892C34367760379561D@GNBEX01.gnb.ca>
Content-Type: text/plain; charset="us-ascii"

If it doesn't like a thread cutting die on them, then I wouldn't do that.
I just clean them with a wire brush, and make sure the head cap nuts, all of
them, screw on nicely. And I lube the threads lightly. 
Scott
www.turbovans.com 

-----Original Message-----
From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of
Giasson, Pascal (DNR/MRN)
Sent: Wednesday, March 19, 2008 10:08 AM
To: vanagon@GERRY.VANAGON.COM
Subject: Cleaning head stud threads question

It is widely recommended to clean up the threads on the head studs
before putting the heads and cap nuts back on.  So I am trying to do
that with my 10x1.5 die and it seems to go on very hard.  Thinking that
I must had a bad die, I borrow a friends die and it goes on slightly
better but it still seems to be quite tight and does not seem normal to
me.  Is this normal for these studs?  Should I just lube them up and
chase them with the die?  Thanks

Pascal

'84 Westy

 


-- 
No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.519 / Virus Database: 269.21.7/1335 - Release Date: 3/19/2008
9:54 AM