Date: Fri, 28 Mar 2008 08:37:38 -0700
Reply-To: neil N <musomuso@GMAIL.COM>
Sender: Vanagon Mailing List <vanagon@gerry.vanagon.com>
From: neil N <musomuso@GMAIL.COM>
Subject: Re: Steering Wheel Adust/Horn sounds
In-Reply-To: <5a099d980803271428r63cae73eg1351abd973d527af@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1
Check the archives for stuff on the horn ring on steering wheel. I
can't recall the exact anatomy of the steeering column right not, but
the scraping could be the ring or contact, debris in the way, or could
the wheel be scraping against the black tube? (that part of anatomy I
can't recall right now)
As far as horn sounding, check the wire going through steering column
and spade connector at coupling. (flanges) It could be frayed.
I loosened/tightened the steering wheel nut by placing a piece of 2x4
under arm in steering wheel. The rubber in arm may flex a little, but
it shouldn't hurt it.
Neil.
On Thu, Mar 27, 2008 at 2:28 PM, Neil Crawford <vidublu@gmail.com> wrote:
> Well I R&R'd the entire ignition switch housing and combo switch,
> again, y'day and this is what I found:
>
> * The contacts on the lower (right/wiper control) assembly of the combo
> switch were gunked up. I cleaned them with Ralph Lauren's Polo!
> * The two contacts on the lower assembly are not making (or breaking) and
> it appears they haven't for years.
> I just scavenged this ComboSwitch from an '85 recently and had previously
> there was a fault in it, vice the steering wheel that was causing the horn
> to sound.
> * The ignition switch screw wasn't seated completely. I'm unsure if that
> was my bad or it worked loose with all the adjustments I've made while
> attempting to get the horn to stop sounding.
> * The black nylon sleeve isn't the same on both ends and I reversed it. It
> now has the solid end downward and the end with the notches upward.
> * The wheel is still loose (while I grasp at 3 & 9 o'clock and tilt it
> toward the windshield or down toward the deck), unless I tighten the large,
> top nut down unreasonably tight.
> * There are about five threads or 3/8" of thread btwn the top edge of the
> steering wheel bolt and the surface of the steering wheel base (before
> installing the large, top nut, for what that's worth.
> * If I snug the top nut the horn doesn't sound when turning the swheel
> about 180 degrees.
> * If I tighten the top nut the horn sounds when turning the swheel about
> 180 degrees.
> * If I tighten the top nut to the point that the wheel no longer tilts
> significantly the horn sounds continuously.
> Generally, the tighter the top nut, the louder the scraping sound becomes.
>
> Questions:
>
> I find it difficult to believe the lack of the two 3'o'clock contacts
> making/breaking would cause the horn to sound. Does anyone else agree?
> Does anyone know what these contacts are used for? I'm beginning to think
> the horn cicuit is Normally Closed. Anyone know fer sure?
>
> Do I now have the black, nylon sleeve correctly? Does it matter? I thought
> the orientation might affect the tilting but it doesn't seem to relate.
>
> How tight do ya'll tighten the large, top nut? Or, how many threads are
> showing above yours?
>
> Given the last three bullets above, what do ya'll deduce?
>
>
> Penny for your thoughts?
>\
|