I think that would be a great spot. Two things you might run into; metric hole and standard threads, there's not a lot of room between the push rod tubes. If the sensors are inexpensive you might think about installing them in a couple other places. The vent hole of the radiator comes to mind or the top of the cooling tower like you mentioned. Then select them with a rotary switch. Ken Lewis On Tue, April 1, 2008 1:39 pm, Todd P. Last wrote: > I've often wondered if you could mount the sensor in either one of > the threaded drains for the heads (replacing the existing bolt) or > in one of the ends of the plastic coolant tower by the starter. > Anyone try this? > > Todd > '88 Westy > > Slloth wrote: Anyone have instructions on in stalling an after market > temp gauge? I > think I want to run an additional gauge mounted somewhere on the dash > panel just for a "back up" to the stock gauge. > > -- > ’84 Westfalia Gasoline > > |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.