Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 2008, week 4)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Tue, 22 Apr 2008 06:36:09 -0400
Reply-To:     Dennis Haynes <d23haynes57@HOTMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
Comments:     RFC822 error: <W> MESSAGE-ID field duplicated. Last occurrence
              was retained.
From:         Dennis Haynes <d23haynes57@HOTMAIL.COM>
Subject:      Re: What does your oil pressure gauge "say",
              and what other gauges do you have in your Vanagon
Comments: To: Richard Golen <rgolen@UMASSD.EDU>
In-Reply-To:  <20080421141658.99B1F3284E9@mail.umassd.edu>
Content-Type: text/plain; charset="iso-8859-1"

Running a Water Boxer on 10w-30 is asking for engine failure to begin with. Very risky for extended highway travel. You really want 20w-50 or 15w-50 synthetic. The WB wants and needs a high viscosity oil. Your gauge is probably enthusiastic at the low end reading 15 psi at idle with that oil Especially since your at 30 at 4,000 rpm. This is close to the wear limit of 28. FUN BUS still hold 40-45 psi at highway speeds with 254k on the engine. 10 psi/1,000 rpm is sort of a universal baseline for most engines. Where did you connect the gauge to the engine? Best spot is where the low pressure sensor sits between the pushrod tubes.

Dennis

-----Original Message----- From: Vanagon Mailing List [mailto:vanagon@gerry.vanagon.com] On Behalf Of Richard Golen Sent: Monday, April 21, 2008 10:17 AM To: vanagon@GERRY.VANAGON.COM Subject: What does your oil pressure gauge "say", and what other gauges do you have in your Vanagon

Hi,

This weekend I put in a 3 gauge panel in my Vanagon. One of which is an oil pressure gauge. As I haven't had an oil pressure gauge in a Vanagon before, I need a "baseline" to compare my readings with. Currently, my 87 Westy as 155K miles, and I have 10W30 oil in it. When warmed up, idle pressure is 15psi, at 3K RPM - 30psi, at 4K RPM - 40psi. What oil pressure readings do you get in your Vanagons?

As far as the other gauges in the panel, I have a 12V voltmeter. The third gauge is a temperature gauge. The temp gauge came from my old 86 GTI (as did the voltmeter), however I do not have it hooked up as I don't have the sensor for it, and on the GTI I was able to run the sensor off of the oil cooler. The Vanagon oil cooler doesn't seem to have a place to put the temp sensor. So, rather than having a non-functioning gauge filling up the spot on the gauge panel, I'm curious as to what other gauges you folks might have in your Vanagons.

Thanks.

Ric


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.