craig cowan wrote: > If its coaxial cable (A cable inside a cable) that works essentially as two > wires, how can it operate with a simple spade connector? Wouldn't that alone > default it to ground? If not....how do i keep the two parts seperated > through a spade connector, and reattached at the other end? Only the run from the ECU to the spade connector for the O2 sensor is shielded. The run from the O2 sensor to the spade connector is not shielded. The shielded wire must only be grounded at ONE end (at the ECU end). If it's grounded at both ends it won't work as a shield and will cause problems. Mike |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.