Does anyone have any baseline readings for the Temp 2 sensor? I have the Digijet Digitool hooked up to it and with the temp needle @ halfway on the LED the reading is .01-.02...the fan isn't kicking on, but I was told the voltage should be @ ~ .05-.06... Am I running too hot? is the thermostat not opening all the way? I am not experiencing any running problems, but I was curious if those numbers sound WAY off or not... Normally, the fan comes on when the needle goes completely above the LED and then turns off once its about 3/4 high in the LED... -- Dave - KC9FYM http://fjazzbass.blogspot.com |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.