Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2008, week 1)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 4 May 2008 17:02:24 -0700
Reply-To:     Mark Drillock <mdrillock@COX.NET>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Mark Drillock <mdrillock@COX.NET>
Subject:      Re: Coolant temp sensor
Comments: To: kayakjr@COMCAST.NET
In-Reply-To:  <050420081737.25290.481DF46600046C04000062CA22155688849D06050E970E05@comcast.net>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

The 2.1 in 2wd models uses rubber o-rings for both.

The 1.9 and Syncro with 2.1 use metal washers/rings for both.

Mark

John Reynolds wrote: > Can anyone tell me if the coolant gauge temperature sensor (in thermostat housing - not the level sensor in the expansion tank) uses an O-Ring? I' can't tell if this sensor and it's cousin for the fuel injection make direct contact with coolant and need a o-ring of some sorts. > > John >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.