I'm planning on running a wire from my oxygen sensor up to the front of the van for a air/fuel mixture gauge (i.e., voltmeter). I'm planning on running a wire off where the wiring harness connector is in the engine bay. I've heard the the oxygen sensor wire is shielded, and figure I better use shielded wire to run back there from the front. The only shielded wire I saw at radio shack was double-wire audio cable. Is the shielded wire necessary? Any ideas where I could find some thin shielded wire locally?
(In case it matters, my sensor is the 1-wire style.) Thanks! -Wes '83 1.9l vanagon. |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.