In a message dated 5/21/08 1:28:00 PM Eastern Daylight Time, magikvw@GMAIL.COM writes:
> Ok folks I have a question. I'll try not to be vague. > > I have a full length rear seat that folds into a bed - it's not original to > my bus. I don't have the proper "posts" for the latching mechanisim for the > back part when the seat is upright so the back doesn't latch into place. > This for obvious reasons is not safe. The seat has the metal handle in the > middle of the backside that you pull to release it so you can fold it down. > > I guess my question is does anyone know where (or happen to have) I can get > the proper posts so I can latch the thing? > > if you have a carat and you put the regular 7 pass GL weekender sofabed in there then the seatback wont latch properly because the carats have a extra spacer welded to the latch points on the sides of the van because the carat sofabed was narrower chris
************** Get trade secrets for amazing burgers. Watch "Cooking with Tyler Florence" on AOL Food. (http://food.aol.com/tyler-florence?video=4& ?NCID=aolfod00030000000002) |
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.