Date:         Tue, 27 May 2008 17:16:48 -0400
Reply-To:     pyjme@AOL.COM
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Peter Young <pyjme@AOL.COM>
Subject:      Re: 2nd try - Bostig 2nd Gen Zetec Kit
Content-Type: text/plain; charset="us-ascii"

Jim,
You mention "allow(ing) yourself another $800-$1000 for the other 5 parts needed to
finish the install." What are the other 5 parts needed (besides a low mileage engine
from a local source) to finish the install? I also have another question: the oil pan has
been revised to increase departure angle but retain full capacity - is this setup standard
or an option? Is the clearance just as good as (or better than) the previous "short" pan?

Peter
'81 Westy "Daisy"
planning on getting a water-cooled in the future just so I can do the Zetec conversion...

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.