Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (May 2008, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 May 2008 00:10:40 -0400
Reply-To:     Ian Allan <ian.allan@BMTS.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         Ian Allan <ian.allan@BMTS.COM>
Subject:      Bostig Conversion Unabashed (long)
Content-Type: text/plain; charset=WINDOWS-1252; delsp=yes; format=flowed

I intend to post this on the Samba and the Vanagon List. If you watch

both I apologize for the redundancy.

I recently completed a Bostig Zetec conversion of my 1985 Westfalia 4

speed using their version 1 kit.

Today I took my Westy on a 300 mile round trip from my home in rural Ontario to Toronto and back. I used country roads, two and three lane

highways, two expressways and the city streets in Toronto. The van was fantastic. It was quiet, nimble and handled all the different traffic requirements with lots of zip and power to spare. Fuel economy was 12 l/100km or just short of 24 miles per imperial gallon.

The Zetec engine with its increase in power gives the Vanagon an entirely different personality and feel. Imagine thinking about passing that truck in front of you and then actually passing it on an

upgrade!

Last fall I decided that I was going to repower my 85. I also have a 94 Eurovan Westfalia 5 cyl., 5 speed but I just cannot get comfortable with that interior layout. The Eurovan is a strong runner

with more than adequate highway power but it lacks the charm and spaciousness of the Vanagon. I wanted to end up with a Vanagon Westy that I could drive with confidence wherever I chose. Reliability (or perceived reliability), serviceability and improved highway performance were the main goals. I was willing to pay. I didn’t want

to hotrod a rusty old camper, I wanted a solid, reliable machine. My wish list included the engine, transmission, cooling system (rad and tubes), half shafts and brakes.

I liked the idea of a Subaru boxer and at the same time was captivated by the Bostig package. In the end my decision was decided by the ease of communication with Bostig. I am sure that Hans at Vanaru and my countryman Ben (for whom I have great respect) offer a fine Subaru alternative but my connection with Jim Akiba and his quick and complete replies to my questions gave me the comfort level that I needed to take the plunge. BTW, to me the bottom line in this re-power debate was correctly expressed by Benoit earlier this year when he said the real issue is to modernize the great Vanagon design.

And not to get stuck with the WBX architecture. Give the van something to work with, horsepower. Cheers Ben!

I was originally ready to buy a Bostig drop-in when Akiba suggested the kit. Jim told me that if you do the kit you will understand what you have. How right he was. In retrospect getting the engine and dressing it was maybe 30%-40% of the project. Installing the engine, the cooling and the wiring in the Vanagon is the majority of the work. BTW, when you bolt the kit into the Vanagon there are eight bolts to line up. The assembly went in perfectly, without even the use of a pry bar! You would have to do that installation stuff anyway

in the event that you bought a drop-in. My 5000 km. salvage engine cost me $1100.00 c/w alternator, power steering pump, throttle body air box and AFM. I paid Bostig a little over $4000.00 for the kit. I live in Canada so there were some shipping costs and considerations and maybe the salvage engine costs are a little higher but that’s life.

In my case I also bought a rebuilt 4 speed from (Turbo) Daryl at AA Transaxle about $1100.00n I think, stainless cooling tubes from Terry

K about $450.00 and a rad from Bus Depot (Terry’s favorite list vendor) for roughly $150.00. A couple of rebuilt half shafts will set

me back maybe $275.00 for the pair and I think that the rear brake stuff will run around $100.00. So for less than $7500.00 I get a rust

free Vanagon with a complete new drive train, good brakes and cooling

system good for another twenty years. That is hard to beat!

You could do the performance enhancements for 5K, plus the drive train/cooling hardware/brakes for 7.5K and probably with a body job, new paint and tires for 10k.

The real deal with Bostig so far as I am concerned is the support. Brady and Jim answer every email and usually within a few hours. If you call Bostig the chances are Jim or Brady will answer the phone. Early on Jim said to me some of these guys (the conversion owners) don’t change their own oil! Ahem, ha ha ha I thought “when is the

last time I changed my own oil?” I couldn’t get the date. In the end it was nice to revisit some old skills, to develop some new ones, to take some responsibility and to know that there is a whole community of support on the other end of this internet connection. One thing that I have learned so far about this VW community is that you don’t

have spend a lot of time worrying about getting screwed. VW people don’t do that to each other.

Thanks Jim, thanks Brady. Your precision kit made my day.

And BTW the Bostig Vanagon was the hit of the Wiarton Cruise Night among the big Detroit iron. I think they liked the Ford insignia on the cam coverJ


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.