Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 2008, week 5)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Thu, 29 May 2008 10:17:15 +0000
Reply-To:     R DIXON <dickd@SYMPATICO.CA>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         R DIXON <dickd@SYMPATICO.CA>
Subject:      Re: A/C leaking
Comments: To: kimbrennan@mac.com, michbriss@hotmail.com
In-Reply-To:  <75A54D1E-A8E8-4316-8023-7870165015B5@mac.com>
Content-Type: text/plain; format=flowed

KimB & JackR

Thanks for your responses to my A/C question - it does appear to me to be related to the drip lines. I tried earlier to get at the evaporator tray by taking off several bolts and screws but was unsuccessful - I should mention I have a Westy camper and the added features make it difficult to make some repairs. I will try again later this week-end using your methods.

Thanks, Richard

>From: Kim Brennan <kimbrennan@mac.com> >To: Richard Dixon <dickd@SYMPATICO.CA> >CC: vanagon@GERRY.VANAGON.COM >Subject: Re: A/C leaking >Date: Tue, 27 May 2008 22:27:42 -0400 > >Problem? > >Well, the main issue may be that your drip lines are clogged. However, in >very humid situations, with a very good working AC unit, it can be that >your whole system is causing the moisture to condense. > >Access to the drip lines can be tricky. Presuming this is a passenger van, >you may be able to access them from the D pillar openings on the outside. > >Under normal circumstances, there is a drip tray under the evaporator >portion of your AC (that portion that is in the rear above the cargo area) >The drip tray has rubber tubes that feed into the D pillars and allow >condensation to drip outside. Those tubes could be clogged, or (if your AC >has been worked on) they could be kinked, or even not inserted properly so >as to prevent the condensation (water) from going outside. > >And you could have a nice puddle of water in your drip tray as a result. > >Lowering the plastic housing that holds the evaporator can gain you access >to the rubber tubes. Be careful as the evaporator is fairly heavy. To >lower it, you will need to remove the 6 bolts on the front of the housing >and the plastic housings covering the D pillar. You might try only >removing one side and lower it a bit to gain access. > > >On May 27, 2008, at 7:46 PM, Richard Dixon wrote: > >>I'm wondering if any owners have had this air conditioning problem: At >>end of last summer during a hot spell, as A/C did its work, moisture >>started to drip above the rear cargo area. Any ideas on repairing this >>problem? >


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.