Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 2008, week 2)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 8 Jun 2008 10:04:04 -0700
Reply-To:     neil N <musomuso@GMAIL.COM>
Sender:       Vanagon Mailing List <vanagon@gerry.vanagon.com>
From:         neil N <musomuso@GMAIL.COM>
Subject:      Re: transaxle being rebuilt
Comments: To: Polly <wognacious@gmail.com>
In-Reply-To:  <ffd4a3960806080943y477d7a4cldd231d5bf84fd9d7@mail.gmail.com>
Content-Type: text/plain; charset=ISO-8859-1

Check input shaft seal and small-ish dome shaped seal inside each flange on tranny, (where inboard CV bolts to) inspect cross shaft for play/wear, (especially bushings on Driverside end..... make sure the bolt holding these bushings in position is doing its' job) if ok add some grease to both ends of cross shaft, inspect throwout bearing tube, (not loose or excessively worn.... add a little grease to it when putting things together) throw out bearing, (turns easily, but doesn't spin too long and/or have excessive play) make sure throw out bearing is installed correctly.

Cheers,

Neil.

On Sun, Jun 8, 2008 at 9:43 AM, Polly <wognacious@gmail.com> wrote: > Just fishing for suggestions on maintenance stuff while the transaxle is > out. Already doing CV joints, starter and boots. What else? > TIA, > Paul >

-- Neil Nicholson '81 JettaWesty "Jaco http://groups.google.com/group/vanagons-with-vw-inline-4-cylinder-gas-engines http://web.mac.com/tubaneil http://tubaneil.googlepages.com/


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.